Apollo Accelerators

Apollo Accelerators Discussion Forum
» » »
[Post Reply] [*]  Page 1 of 1  [ 2 posts ]
Author Message
Violo
Post subject: Vampire 600 V2 and Micro SD card Driver Posted: Sun 9 Jul 2017 15:31
Offline
Posts: 14
Joined: Wed 5 Jul 2017 08:24
Hi,
i followed the SD card install procedure and i have these doubts:
1) "Install PFS3" ... and below is written "copy x.x into c: drawer" means that i have to install the software (by clicking installer and follow the installer procedure) or is enough to copy the single file?

2) About step 1.4 "Check installed files", everything match with the guide but i don't have all the file into RAM drawer. I have only the standard T, ENV and Clipboard, why?

3) At the end of the procedure i write sddiag into CLI and SD card is correctly seen. After is suggested to write SCSIQuery into CLI window to double check the SD geometry. When i write SCSIQuery CLI answers to me "Missing parameters"... how SCSIQuesry command works?

4) Going on i type on a CLI window "SYS:Tools/HDToolBox device=sagasd.device" and HDToolBox appear... but list is empty.

Thank for support!


Top
[Profile] [Quote]
Violo
Post subject: Re: Vampire 600 V2 and Micro SD card Driver Posted: Wed 19 Jul 2017 17:22
Offline
Posts: 14
Joined: Wed 5 Jul 2017 08:24
Nobody know the answer?

Or i write in wrong topic?


Top
[Profile] [Quote]
Display: Sort by: Direction:
[Post Reply]  Page 1 of 1  [ 2 posts ] Return to “Help and tutorials”

Jump to: 

Who is online

Users browsing this forum: No registered users and 1 guest


» The team | Delete all board cookies | All times are UTC+01:00

cron