Apollo Accelerators

Apollo Accelerators Discussion Forum

Install SD Card Driver

Post Reply   Page 1 of 1  [ 7 posts ]
Author Message
Violo
Post subject: Install SD Card Driver
Posted: Wed 5 Jul 2017 20:36
Offline
 
Posts: 14
Joined: Wed 5 Jul 2017 08:24
 
Hi,
i followed the SD card install procedure and i have these doubts:
1) "Install PFS3" ... and below is written "copy x.x into c: drawer" means that i have to install the software (by clicking installer and follow the installer procedure) or is enough to copy the single file?

2) About step 1.4 "Check installed files", everything match with the guide but i don't have all the file into RAM drawer. I have only the standard T, ENV and Clipboard, why?

3) At the end of the procedure i write sddiag into CLI and SD card is correctly seen. After is suggested to write SCSIQuery into CLI window to double check the SD geometry. When i write SCSIQuery CLI answers to me "Missing parameters"... how SCSIQuesry command works?

4) Going on i type on a CLI window "SYS:Tools/HDToolBox device=sagasd.device" and HDToolBox appear... but list is empty.

Thank for support!


Top
Profile Quote
Violo
Post subject: Re: Install SD Card Driver
Posted: Wed 19 Jul 2017 17:23
Offline
 
Posts: 14
Joined: Wed 5 Jul 2017 08:24
 
Nobody here had use the SD card slot?
No suggestion for me?


Top
Profile Quote
Uigiflip
Post subject: Re: Install SD Card Driver
Posted: Thu 20 Jul 2017 00:32
Offline
 
Posts: 30
Joined: Sat 19 Nov 2016 18:07
 
I think the sd gets installed when install rtg driver


Top
Profile Quote
SpacemonkeyUK
Post subject: Re: Install SD Card Driver
Posted: Fri 21 Jul 2017 00:41
Offline
 
Posts: 35
Joined: Mon 5 Dec 2016 11:21
 
http://wiki.apollo-accelerators.com/dok ... _driver_sd


Top
Profile Quote
Violo
Post subject: Re: Install SD Card Driver
Posted: Mon 24 Jul 2017 09:10
Offline
 
Posts: 14
Joined: Wed 5 Jul 2017 08:24
 
Yes, as you can read i follow this steps, i and ask question about some guide points...


Top
Profile Quote
SpacemonkeyUK
Post subject: Re: Install SD Card Driver
Posted: Mon 24 Jul 2017 13:41
Offline
 
Posts: 35
Joined: Mon 5 Dec 2016 11:21
 
SCSIQUERY sagasd.device
If you run SDMount then the disk should be present in HDTool box and then allow you the partition

Giggledisk Device=sagasd.device Unit=0 To=RAM:SDcard

This will create a file that you can use as a mount file


Top
Profile Quote
Violo
Post subject: Re: Install SD Card Driver
Posted: Tue 25 Jul 2017 17:00
Offline
 
Posts: 14
Joined: Wed 5 Jul 2017 08:24
 
thanks for suggestions... what about question 1 and 2? I think they are simplier that others... ;)


Top
Profile Quote
Display: Sort by: Direction:
Post Reply   Page 1 of 1  [ 7 posts ]
Return to “Vampire 600 V2”
Jump to:
cron