i followed the SD card install procedure and i have these doubts:
1) "Install PFS3" ... and below is written "copy x.x into c: drawer" means that i have to install the software (by clicking installer and follow the installer procedure) or is enough to copy the single file?
2) About step 1.4 "Check installed files", everything match with the guide but i don't have all the file into RAM drawer. I have only the standard T, ENV and Clipboard, why?
3) At the end of the procedure i write sddiag into CLI and SD card is correctly seen. After is suggested to write SCSIQuery into CLI window to double check the SD geometry. When i write SCSIQuery CLI answers to me "Missing parameters"... how SCSIQuesry command works?
4) Going on i type on a CLI window "SYS:Tools/HDToolBox device=sagasd.device" and HDToolBox appear... but list is empty.