Apollo Accelerators
http://forum.apollo-accelerators.com/

Active cooling needed/recommended for the Vampire?
http://forum.apollo-accelerators.com/viewtopic.php?f=5&t=1915
Page 1 of 1
Author:  Eratosthenes [ Mon 11 Jun 2018 21:38 ]
Post subject:  Active cooling needed/recommended for the Vampire?

Hi everybody,

I'm one of the lucky ones who has been informed that his Vampire 2 will be shipped soon... :shock: :D :mrgreen:

As I'm a bit "concerned about heat in the tiny case" I've installed a cooler for my acually installed Furia card.

[ img ]

My question: Should I keep this vent when running the vampire or is it obsolete when running an FPGA card?

Thanks for info.

MfL
der Eratosthenes

Author:  TuKo [ Sun 17 Jun 2018 21:08 ]
Post subject:  Re: Active cooling needed/recommended for the Vampire?

Cyclone 3 used in the Vampire V2 is generally not very hot and doesn't even need a dissipator.

But the A600 case is so small and airflow is so bad that any help for cooling will not hurt.

Author:  Eratosthenes [ Sun 8 Jul 2018 15:02 ]
Post subject:  Re: Active cooling needed/recommended for the Vampire?

OK, so I will keep the vent. As it's a bit noisy I will slow it down a bit. I think that it also will work when not turning at 6.000/min... ;->

Page 1 of 1 All times are UTC+02:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/