I need some help with my Vampire 500+
Since I bought my Vampire 500+ from Igor, I had never flashed its core.
The last week-end, I have flashed the V500+ with the core 2.8 with the command line in a cli.
The flash has been perfectly done.
After a long switch off, I have launched my A500 with Coffin r48 onto a CF card.
Onto the HDMI monitor, I can see the Core 2.8 boot picture... Beautiful!
After, the system launchs. But it doesn't launch the Workbench.
I obtain only a grey empty screen as showned in the picture below. The mouse moves well into the screen.
When the A500 boots onto the HD2 partition, the menu of the recovery tools appears onto the crt monitor.
When the A500 boots with a standard 3.1 system installed onto a CF card, eveything works fine onto the crt monitor, but no signal onto hdmi monitor since I didn't install the Picasso driver.
I don't understand what is happening. Core update has been done without error. Coffin r48 had been put onto a 32GB Transcend 400x UDMA7 CF card with dd command line under Linux.
Thanks a lot for your help!