The v2expeth.device is included in the SagaDriver.1.3.lha archive. It does not get installed by default.Unpack the archive and go to Devs/Networks. You will set it there.
It can be found here: http://www.apollo-accelerators.com/file ... r.v1.3.lha
The Apollo Vampire update site is here: http://wiki.apollo-accelerators.com/dok ... test_cores
. You should visit this site often to check for updates.
The status light on mine is green. I see some pictures on the Net that show it red. Mine is green at all times even with no Ethernet cable connected or drivers installed. Still trying to find if the color of the status LED means anything other than the board is getting power. Perhaps they are single color LEDs that could be Green of Red when assembled?
Check your wiring and try the driver. Good Luck!